Cutter Cover Install—020811 pg. 4
Carousel Mate—Cutter Cover Installation
5. Using an 1/8” Allen Wrench insert set screws into the holes to secure the cover.
Once the set screws have been tightened proceed to tighten the screws on the
cover to secure it in place.
Cutter Cover Install—020811 pg. 9
Cutting Bar—Cutter Cover Installation
5. Using an 1/8” Allen Wrench insert set screws into the holes to secure the cover.
Once the set screws have been tightened proceed to tighten the screws on the
cover to secure it in place.
To Next Page
Loading...