CarouselMate-PM-Checklist�indd
Service: 1-866-821-2647
O ce: 1-800-210-0141
www�storevertical�com
Page 1
Conclusion: This unit has been inspected and serviced for safe operation and is operating as intended by the manufacturer�
Comments and Parts Used (If any):_____________________________________________________________________________
__________________________________________________________________________________________________________
__________________________________________________________________________________________________________
__________________________________________________________________________________________________________
__________________________________________________________________________________________________________
Indicates item is inspected and in good condition - Indicates item requires additional service
Service Initials
Check guide rail for damage�
Roll unit back & forth to check the retractable cord reel to ensure that it is
in good condition�
Inspect cord end for any damage�
Check counter calibration with a tape measure�
Ensure counter wheel spins freely�
Clean and lubricate caster wheels�
Check rear plastic track wheels�
Check cutter chain tension�
Check re-roller to ensure latches are in good condition and working properly�
Inspect cutter blades and change as needed (should be easy to insert blades� If not, clean
debris from blade slots)�
Inspect and lube re-roller drop down pivot points�
Inspect re-roller drop down latch mechanism for proper operation�
Carousel Mate Preventative Maintenance Checklist
Fax completed checklist to 1-204-364-3072 Attn: Service Manager or e-mail to service@vidir�com
Required Components
Company City Province Date of Service:
Store No� Serial No� Model/Type Current Hour Meter Reading
Service Company: Store Signo :(Print)
Service Technician (Print): Store Title:
Service Tech Signature: Store Signature:
Preventative Maintenance is Recommended Every 100 Hours or 12 Months. Inspect both sides of the machine.
The inspection of all hooks, bolts, pins, mounting hardware, chains and the overall condition of these components
are critical to ensure machine safety, and integrity of the preventative maintenance process� Initialling each line as
indicated below con rms these items have been thoroughly inspected for defects�
Parts technician should have on hand for each store that a PM is being done� Estimated time to complete
PM about 1/2 hour per machine�
Qty Description Part # Qty Description Part #
4 blades 103-0012 2 Connector links 105-0068
To Next Page
Loading...