Viessmann VITOCAL 300 - Heat Pump;Heating Circuit Settings; General

14
Heat pump/heating circuit settings
General
All control circuits controlled by the control unit are displayed as symbols,
when the programming unit flap is closed.
After key
C
for "Programme" has been pressed, and when the
programming unit flap is open, all control circuits will be called up via the
alpha keys. Depending on the system version, the following options are
offered:

A
"Heat pump"

B
,
C
"DHW cylinder" (domestic hot water cylinder)

B
,
C
,
D
,
E
"Mixer" (heating circuit with mixer), "Solar collector"
A directly connected heating circuit (without mixer) will not be shown in the
display field, as it is regulated via the "heat pump" settings.
By way of example for all possible system versions, this manual describes a
heat pump system comprising:
 One DHW cylinder and
 One heating circuit with mixer.
Implement settings for all further control circuits in accordance with those
described here.
The settings for heat pumps and heating circuits with mixers are in type and
function identical. Therefore, the following section describes both.
5592 415GB