Viessmann VITOCAL 300 - System with Remote Control; Remote Control; Setting the Operating Mode at the Remote Control; Setting the Room Temperature at the Remote Control

1
0
2
34
5
1
2
34
5
1
35
System with remote control
Remote control
When using a remote control unit, select the settings for the allocated heating
circuit at the relevant remote control. The control unit settings apply either to
a further heating circuit or have no effect.
Setting the operating mode at the remote control
Timer operation
The switching times for the
heating circuit set at the control
unit are effective.
Standard operation
The heating circuit will be
regulated to the standard room
temperature set at the control
unit.
Reduced operation
The heating circuit will be
regulated to the reduced room
temperature set at the control
unit.
Off
The heating circuit will not be
heated.
Setting the room temperature at the remote control
You can make a correction using
rotary selector 1, if the actual room
temperature does not correspond to
the required temperature.
To change the standard temperature
set at the control unit (see page 16)
by 1 ºC, turn rotary selector 1 by
one increment either towards "+" or
"".
5592 415GB