Viessmann VITOCAL 300 - Setting Temperatures; Changing Switching Times

21
DHW cylinder settings
Setting temperatures
DHW cylinder 1 [ºC]
Current op. mode : ON
DHW cylinder temp. : 45.0
Timer/switching times
±
°
+1.0 1.0
STANDA
BACK
Open the programming unit flap and
press the following keys:
1.
C
for "Programme".
2.
B
for "DHW cylinder 1".
3.
±
/
°
press until
"DHW cylinder temp."
is highlighted.
4.
+1.0
/
1.0
press until the required
temperature is shown.
5.
BACK
press to confirm.
Changing switching times
For heat pumps with DHW cylinder, the DHW heating can be switched on and
off several times each day using corresponding switching times.
You can select identical switching times for all weekdays or individual ones
for every weekday.
When setting the switching times take the response time of your heating
system into consideration. Select correspondingly earlier start−up and
switch−off times.
Key to graphics
03691215182124
LOADING
*1
HO
E USE
*2
EE
HP ON WP
OFF AU
  
The height of the bar and the
alphabetical abbreviation indicate
the respective operating mode
associated with the displayed time.
*1
Electrical re−heating to a higher temperature level.
*2
Heating with additional heat source, e. g. electric immersion heater.
5592 415GB