Viessmann VITOPEND - Setting the Operating Program for Central Heating; Setting the Time Program for Central Heating; Heating Curve

26
Setting the operating program for central heating
For the preferred heating circuit For all heating circuits
Standard menu
1. / for the operating program:
"Heating and DHW"
2. OK
Extended menu
1.
2. "Heating"
3. / for the required heating circuit if
necessary
4. "Heating program"
5. e.g. "Heating and DHW"
For information on the operating pro-
grams, see page 18.
Time program
Further information can be found
in chapter "Terminology" in the Ap-
pendix.
Setting the time program for central heating
Factory setting: One time phase from
6:00 to 22:00 h for every day of the
week
Extended menu:
1.
2. "Heating"
3. / for the required heating circuit if
necessary
4. "Heating time program"
5. Set the required time phases.
Procedure for setting a time program,
see page 19.
Note
When adjusting the setting, bear in mind
that your heating system requires some
time to heat the rooms to the required
temperature.
Heating curve
Further information can be found
in chapter "Terminology" in the Ap-
pendix.
Central heating
Operating program
(cont.)
5592 682 GB