Viessmann Vitotwin 300-W - Cleaning the Heating Surfaces and Fitting the Burner

75
Cleaning the heating surfaces and fitting the burner
!
Please note
Scratches on parts that are in
contact with flue gas can lead to
corrosion.
Never use brushes to clean the
heating surface.
B
A
01.
Remove separating plate A from
heating surface
B
.
02. Close opening in the lower, rear part
of heating surface
B
(seal with
adhesive tape), so that liquids can-
not enter the Stirling burner.
Commissioning, inspection, maintenance
Further details regarding the individual steps
(cont.)
5618 294 GB
Service