EasyManuals Logo

ViewSonic PJD5112 User Manual

ViewSonic PJD5112
43 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
EN-25
Replacing the Lamp
As the projector operates over time, the brightness of the projector lamp gradually
decreases and the lamp becomes more susceptible to breakage. We recommend
replacing the lamp if a warning message is displayed. Do not attempt to replace the
lamp yourself. Contact the qualified service personnel for replacement.
The lamp is extremely hot right after turning off the projector. If you touch the
lamp, you may scald your finger. When you replace the lamp, wait for at least
45 minutes for the lamp to cool down.
Do not touch the lamp glass at any time. The lamp may explode due to
improper handling, including the touching of the lamp glass.
Lamp lifetime may differ from lamp to lamp and according to the environment
of use. There is no guarantee of the same lifetime for each lamp. Some lamps
may fail or terminate their lifetime in a shorter period of time than other similar
lamps.
A lamp may explode as a result of vibration, shock or degradation as a result of
hours of use as its lifetime draws to an end. Risk of explosion may differ
according to the environment or conditions in which the projector and lamp are
being used.
Wear protective gloves and eyeglasses when fixing or detaching the lamp.
Faster on-off-cycles will damage the lamp and reduce lamp life. Wait at least
for 5 minutes to turn off the projector after powering on.
Do not operate the lamp in proximity to paper, cloth, or other combustible
material nor cover it with such materials.
Do not operate the lamp in an atmosphere containing an inflammable
substance, such as thinner.
Thoroughly ventilate the area or the room when operating the lamp in an
oxygen atmosphere (in the air). If ozone is inhaled, it could cause headaches,
nausea, dizziness, and other symptoms.
The inorganic mercury is involved in the lamp. If the lamp bursts, the mercury
inside the lamp will be exposed. Leave the area immediately if the lamp
shatters while being operated and ventilate the area for at least 30 minutes in
order to avoid the inhalation of mercury fumes. Otherwise it could be harmful to
user’s health.

Other manuals for ViewSonic PJD5112

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ViewSonic PJD5112 and is the answer not in the manual?

ViewSonic PJD5112 Specifications

General IconGeneral
Projection distance1.2 - 10 m
Projection technologyDLP
Contrast ratio (typical)2000:1
Projector native resolutionSVGA (800x600)
Aspect ratio4:3, 16:9
RS-232 ports1
Dimensions (WxDxH)280 x 218 x 114 mm
Power requirements90~240VAC
Lamp power180 W
Light source typeLamp
Service life of light source3000 h
Service life of light source (economic mode)5000 h
FocusManual
RMS rated power2 W
Headphone outputs2
Serial interface typeRS-232
Noise level30 dB
Power consumption (standby)1 W
Power consumption (typical)235 W
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)10 - 90 %
Product typeStandard throw projector
Market positioningPresentation
Weight and Dimensions IconWeight and Dimensions
Weight2600 g

Related product manuals