ViewSonic PJD5112 User Manual

EN-5
Introduction
Projector Features
The projector integrates high-performance optical engine projection and a user - friendly
design to deliver high reliability and ease of use.
The projector offers the following features:
 Single chip 1.397cm / 0.55" Texas Instruments DLP
®
technology
 SVGA (800 x 600 pixels)
 Auto image re-sizing (Auto-Sync.) to 800 x 600 full screen with scaling
compression compatibility for VGA, SVGA, XGA and SXGA
 Compatibility with Macintosh
®
computers
 Compatibility with NTSC, PAL, SECAM and HDTV
 D-Sub 15-pin terminal for analog video connectivity
 User-friendly, multi-language on-screen display
 Advanced electronic keystone correction
 RS-232 connector for serial control
 The information in this manual is subject to change without notices.
 The reproduction, transfer or copy of all or any part of this document is not
permitted without express written consent.

ViewSonic PJD5112 Specifications

General

Projection distance	1.2 - 10 m
Projection technology	DLP
Contrast ratio (typical)	2000:1
Projector native resolution	SVGA (800x600)
Aspect ratio	4:3, 16:9
RS-232 ports	1
Dimensions (WxDxH)	280 x 218 x 114 mm
Power requirements	90~240VAC
Lamp power	180 W
Light source type	Lamp
Service life of light source	3000 h
Service life of light source (economic mode)	5000 h
Focus	Manual
RMS rated power	2 W
Headphone outputs	2
Serial interface type	RS-232
Noise level	30 dB
Power consumption (standby)	1 W
Power consumption (typical)	235 W
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %
Product type	Standard throw projector
Market positioning	Presentation

Weight and Dimensions

Weight	2600 g