ViewSonic PLED-W500 - On-Screen Display Menus; How to Operate

22
The Projector has multilingual On-screen Display menus that allow you to
make image adjustments and change a variety of settings. The projector
will automatically detect the source.
How to operate
1. To open the OSD menu, press the “Menu” button on the remote control or on the
control panel.
2. :KHQ26'LVGLVSOD\HGXVHWKHŻŹEXWWRQVWRVHOHFWDQ\LWHPLQWKHPDLQ
PHQX:KLOHPDNLQJDVHOHFWLRQRQDSDUWLFXODUSDJHSUHVVWKHźEXWWRQWR
enter sub menu.
3. 8VHWKHŸźEXWWRQVWRVHOHFWWKHGHVLUHGLWHPDQGDGMXVWWKHVHWWLQJVE\WKH
ŻŹEXWWRQV
4. If the setting has
LFRQ\RXFRXOGSUHVVWKHŹEXWWRQWRHQWHUDQRWKHUVXE
menu. Press the “Menu” button to close the sub menu after adjustment.
5. After adjusting the settings, press the “Menu” button to go back to the main
menu.
6. To exit, press the “Menu” button again. The OSD menu will be closed and the
projector will automatically save the new settings.
On-screen Display Menus
Main Menu Sub Menu Settings