Installation Guide MX1 Fire Alarm System (NZ)
LT0360 ISSUE 2.43 29 NOVEMBER 2017 PAGE 24
Final Configuration
The MX1 site configuration data file is created separately and loaded into the MX1 using special software.
Design of the fire alarm system is outside the scope of this installation guide. Refer to the MX1 System
Design Manual (LT0361).
Operation
An MX1 Operator Manual (LT0344) is supplied with each MX1. This manual describes how to use the
alphanumeric display and keypad on the front of the MX1 to view the status of the system and to perform
basic service functions.
For more detailed information about testing and maintenance of the system, refer to the MX1 Service
Manual (LT0366).
Installation Hardware Supplied
EOLRs: 2 x 2.7k, 1 x 9.1k, 2 x 18k, 3 x 27k, 1 x 5.6k
1 x LT0344 MX1 Operator Manual
1 x LT0360 MX1 NZ Installation Guide
1 x LT0356 Inspection Checklist or LT0542 15U Checklist
1 x LM0319 TGEN Connection Loom
4 x M3 x 12mm screws – for mounting optional Zone Display Board, T-GEN, etc.
1 x 003 key
4 x M5 screws, nuts and washers for attaching battery leads to batteries
Battery leads - 1 x Red, 1 x black, 1 x red inter-battery link
2 x LB0600 zone display blanking strips
4 x plastic plugs to fill front service index mounting holes if not used *
2 x FA1163, M4 Barrel Nuts (for Mains Socket) *
1 x Cabinet Mounting Bracket *
1 x Bulgin key for Silence Alarms, Services Restore & Evacuation switches
4 x hex-head screws for mounting front service index *
2 x FU0048, 3A fuses (spares) #
2 x WA0040, M6 plastic washers (spares for door modules) #
1 x LM0231 Earth Loom (spare to earth modules) #
1 x LM0084 long 10-way FRC (for SGD) #
1 x LT0435 Cabinet Mounting Template #
1 x Wormald Domex Label #
To Next Page
Loading...
