Viking Access Systems X-9 - Table of Contents

VIKING TECHNICAL SUPPORT 1.800.908.0884
5
TABLE OF CONTENTS:
PARTS DIAGRAM/PARTS LIST 2
OPERATOR REFERENCES 3
CONTROL BOARD REFERENCES 4
IMPORTANT SAFETY INFORMATION 6-12
Important Safety Instructions 6
Important Installation Instructions 7
Maintenance 8
General Safety Precautions 8-9
Operator Classification 9
Secondary Entrapment Protection Requirements 10
Secondary Entrapment Protection Installation 11
Manual Release 11
Audible Alarm Reset Installation 12
Warning Placard Installation 12
IMPORTANT INSTALLATION INFORMATION 13
Specifications 13
GATE OPERATOR INSTALLATION 14-18
Pull to Open Installation 14
Push to Open Installation 15
Mounting the Gate Operator 16
Post Mounting Option 17
Limit Switch Setup 18
ECU BOX INSTALLATION 19
ELECTRICAL INSTALLATION 20-23
High Voltage Supply Option 20
Low Voltage Supply Option 21
Solar Supply Option 21
Motor Cable 22-23
LIMITS INDICATIONS 24
CONTROL BOARD SETUP 25-28
Initial Settings 25-26
Obstruction Detection Sensor (Primary Entrapment Protection) 27
Heater 28
ACCESSORY CONNECTIONS 29-35
Re-Open Photo Beam (Vehicular Safety) 29
Radio Receiver (Typical) 30
Anti-Tail Gate, Open Commands, Guard Station 31
Viking Loop Rack 32
Guidelines for Loop Installations 33
Magnetic Lock, Lock Solenoid 34
Barrier Arm (B-12) Synchronization Option 35
TROUBLESHOOTING 36-41
LED References 36-37
LCD Display References 38-40
Solutions 41
APPENDIX A, B & C 42-45
VIKING EXPANSION PRODUCTS 46
PARTS DIAGRAM/PARTS LIST
2
OPERATOR REFERENCES
3
IMPORTANT INSTALLATION INFORMATION
13
GATE OPERATOR INSTALLATION
14-18
ELECTRICAL INSTALLATION 20-23
LIMITS INDICATIONS 24
CONTROL BOARD SETUP 25-28
ACCESSORY CONNECTIONS 29-35
TROUBLESHOOTING
36-41
VIKING EXPANSION PRODUCTS
46
APPENDIX A, B & C
42-45
CONTROL BOARD REFERENCES
4
IMPORTANT SAFETY INFORMATION
6-12
ECU BOX INSTALLATION
19