2. SET UP
15
LOWER THE FEED TEETH
To lower the feed teeth you need to remove
the accessory box. The feed teeth lever is
located on the back of the machine at the
base of the free-arm.
Slide the lever (A) to the right to lower the
feed teeth. The feed teeth are raised when you
move the lever (A)to the left. The feed teeth
will come up when you begin to sew or turn
the handwheel towards you. The feed teeth
should be lowered when sewing on buttons.
CHANGING THE PRESSER FOOT
Turn off the main switch
1. Make sure the needle is in the highest
position. Pull the presser foot towards
you.
2. Line up the cross pin on the foot with the
gap in the presser foot ankle. Press back
until the foot snaps into place.
CHANGING THE NEEDLE
Turn off the main switch
1. Use the hole in the multipurpose tool to
hold the needle.
2. Loosen the needle screw (B).
3. Remove the needle.
4. Insert the new needle using the
multipurpose tool. Push the new needle
upwards with the fl at side away from you
until it will go no further.
5. Tighten the needle screw (B).
A
1
2
B
To Next Page
Loading...
