What to do if needle thread breakage or incorrectly threaded condition is detected Viking H|Class 500E Sewing Machine?
If the sewing machine detects needle thread breakage or an incorrectly threaded condition, check the threading and the hoop position.
What to do if SAFTY DEVICE ACTIVATED on Viking Sewing Machine?
If the 'SAFTY DEVICE ACTIVATED' message appears, it means the machine is locked because thread is entangled with the bobbin case or the rotation was forcibly interrupted. Turn off the power switch and eliminate the problem that caused the machine to stop.
Why is my Viking H|Class 500E not turning on? Check cable and power switch?
If your Viking sewing machine isn't turning on, verify that the USB cable is connected and the power switch is turned on.
What to do if small hoop is attached when design for large hoop is transmitted on Viking H|Class 500E Sewing Machine?
If a small hoop is attached when a design for a large hoop is transmitted, turn off the power switch and attach the large hoop. Also, check the hoop position, ensure the feed dogs are lowered, and make sure the first color block has been sent.
What to do if presser foot is not lowered on Viking Sewing Machine?
If the presser foot is not lowered, lower it by using the presser foot lifter.
What to do if bobbin winder is moved to right (operating position) during sewing on Viking Sewing Machine?
If the bobbin winder is moved to the right (operating position) during sewing, check the bobbin winder and move it to the left.
What to do if buttonhole lever is not lowered or raised on Viking H|Class 500E?
If the buttonhole lever is not lowered or raised properly: * Lower the buttonhole lever when sewing buttonholes. * Raise the buttonhole lever when sewing stitch patterns.
What to do if embroidery unit is installed with small hoop attached on Viking H|Class 500E?
If the embroidery unit is installed with a small hoop attached, remove the embroidery unit and the small hoop, and then re-attach the embroidery unit. Alternatively, remove the small hoop and turn the power switch off and on.
What to do if needle is lowered when starting embroidery sewing on Viking Sewing Machine?
If the needle is lowered when starting embroidery sewing, raise the needle by rotating the hand wheel toward you.
What to do if twin needle mode switch is pushed, while patterns without twin needle capability are selected on Viking H|Class 500E Sewing Machine?
If the twin needle mode switch is pushed while patterns without twin needle capability are selected, push the switch again.
Critical safety instructions for operating the sewing machine to prevent hazards.
Overview of machine parts, embroidery unit, hoops, and included accessories.
Comprehensive tables detailing stitch numbers, length, width, and needle positions.
Covers unpacking, connecting power, threading, bobbin winding, and needle insertion.
Guidance on adjusting thread tension, changing presser feet, and replacing needles.
Explains control panel, buttons, stitch length/width, and twin needle feature.
Covers straight stitch, utility stitches, decorative stitches, and buttonholes.
Continuous, novelty, and design stitching techniques.
Covers thread, stabilizer, attaching unit, hooping, and removing components.
Software installation, design management, resizing, editing, and transfer.
Instructions for cleaning, oiling, and general machine maintenance.
Common problems, error messages, and solutions for sewing and embroidery.
Trademark details and guidelines for product disposal.
General| Brand | Viking |
|---|---|
| Model | H|Class 500E |
| Category | Sewing Machine |
| Language | English |
To Next Page