~ 8 ~
UNPACK THE MACHINE
Unpack the machine and place it on a Á at table. Check
the balance of the machine. If the machine does not
stand sturdy on the table, adjust the level of the machine
following these steps:.
Lay machine on its back gently and carefully with both
hands. Be careful not to make scratches on machine and/
or table. Be careful not to drop the machine or to have
your À ngers caught between the machine and table.
Insert the small screwdriver into the hole (1) and adjust the
level of the machine by turning it. After the adjustment,
check that the machine stands sturdy on the table.
Note: Be sure to wipe off any surplus oil from needle plate area
before using your machine the À rst time.
CONNECT THE POWER CORD
AND FOOT CONTROL
Among the accessories you will À nd the power cord and
the foot control.
Note: Before plugging in the foot control, check to ensure that it
is type “YC-485 EC or Model JF-1000” (see underside of foot
control).
1. Connect the foot control cord to the rear socket on
the bottom right side of the machine (1).
2. Connect the power cord to the front socket on the
bottom right side of the machine (2) and your wall
outlet (3) as illustrated.
3. Press the ON/OFF switch to ON (|) to turn on
power and light (4).
2
Set Up Your Machine
1
2
3
14
To Next Page
Loading...
