30
WARNING MESSAGES
The Presser Foot is Not Lowered
If you touch the foot control and the presser
foot is not lowered, the machine will beep and
give you the following message.
Main Motor Blocked
This message means that the thread is twisted
or jammed and the hand wheel motor cannot
move. Look at the trouble shooting guide on
page 43.
The Buttonhole Lever is not Lowered
The buttonhole or darning stich was selected
and the foot control was pressed while the
buttonhole lever was raised.
Buttonhole Lever is not Lifted
A stitch other than the buttonhole or darning
stitch was selected and the foot control was
pressed while the buttonhole lever was down.
Bobbin Winding
The following screen will be shown while you
are winding the bobbin. Once the bobbin is
full and you have pulled the bobbin winder to
the left, the message will disappear.
To Next Page
Loading...
