Viking Emerald 203 - Page 46

44
• Try different spool pin positions
(horizontal or vertical).
• If stitch plate hole is damaged, replace
stitch plate.
• Is the correct spool cap used in front of
the thread?
Fabric Does Not Move?
• Feed teeth up.
• Increase stitch length.
Bobbin Thread Breaks?
• Wind a new bobbin.
• Replace the bobbin in the machine, check
correct threading.
• If stitch plate hole is damaged - replace
stitch plate.
• Clean bobbin area.
Bobbin Winds Irregularly?
• Check threading for bobbin winding.
Wrong Stitch, Irregular or Narrow Stitches?
• Turn machine off and on to reset.
• Change needle, rethread top and bobbin
threads.
• Use stabilizer.
Machine Sews Slowly?
• Check speed
• Remove stitch plate and brush lint from
bobbin and teeth area.
• Have the sewing machine serviced at your
dealer.
Machine Will Not Sew?
• Put bobbin winder spindle up into sewing
position.
• Check plugs are all the way into machine.
• Check wall plug and power to wall plug.
Main Motor Blocked
• Clear out threads in bobbin case area (see
page 42).
• Remove stitch plate and clear out threads
• Re-thread machine - top and bobbin.