14
Setting the cutting height
The apparatus has 6 positions for adjusting the cutting height:
35 mm/25 mm - low cutting height
55 mm/45mm - medium cutting height
75 mm/65 mm - large cutting height
1. Hold the carrying handle ( 6) and lift the device or push the device down.
2. Grip the lever (7) for adjusting the cutting height and move it past the ratchet
mechanism to the desired cutting height.
The correct cutting height is between 25 and 45 mm for an ornamental lawn and about 45
- 65 mm for a utility lawn.
A high cutting height should be selected for the first mowing of the season.
Inserting/removing the rechargeable battery
Switch off the apparatus, remove the ignition key ( 10) and wait for the
blades to come to a standstill.
1. To remove the battery (9) from the device, press the release button (9a) on the battery
and pull the battery out.
2. To insert the battery (9), push the battery along the guide rail into the device. You will
hear it click into place.
Switching on and off
The cordless lawnmower may only be used with Villager 18V batteries. Never use
non-reachable batteries.
• Batteries can leak if they are not handled or used properly. Do not touch fluid leaking
from a battery.
• If you get battery fluid on your skin, rinse immediately in plenty of fresh water. If you
get battery fluid in your eyes, rinse immediately with plenty of water and seek medical
attention.
• Leaking battery fluid can cause skin irritation or burn injuries.
To Next Page
Loading...
