29
Proceed, if you wish, with the own settings, as indicated in
paragraphs 8 and 9 (excluding 9.5 and 9.6).
At midnight the AUTOMATIC operating mode is restored.
To end the JOLLY program, press the pushbutton again.
If you wish to make the JOLLY program start in a day different from
the present day, act as follows:
Take out the body of the equipment and make sure the
AUTOMATIC operating mode is in use.
MALU
048121620
ME GI VE SA DO ON
T3
T2
T1
10.2
Press the pushbutton
and put the day indicator
on the desired day. Press the
pushbutton : a dash is
displayed under the symbol
to confirm the JOLLY program
is set for the desired day.
28
10. JOLLY Program
The equipment is provided with a JOLLY program, suitable for
holidays or festivities during the week, etc. This program can be
started at any moment of the day and kept in operation till the end
of that day, or else it can be scheduled for any day of the week.
The preset thermic cycle is the cycle provided for Saturday and
Sunday (see paragraph 5), but it is also possible to obtain an own
setting, following the instructions indicated in paragraphs 8 and 9
(excluding 9.5 and 9.6).
To start the JOLLY program, act as follows:
Make sure the AUTOMATIC operating mode is in use.
MALU
048121620
ME GI VE SA DO ON
T3
T2
T1
10.1
Press the pushbutton : a
dash is displayed under the
symbol to confirm that
the JOLLY program has
been started.
90716577.L.E 19-09-2003 8:49 Pagina 28
To Next Page
Loading...
