10 - ENGLISH
6. DEVICE CONFIGURATION
This procedure establishes communications between the primary
thermostat and the various devices installed on the system, through
the definition of a configuration table.
WARNING!
Before beginning the configuration, all the devices must be
installed in their definitive positions, and should not be moved
subsequently.
Configuration is carried out from the primary thermostat (logical
ID 01), placing it near the individual devices being included in the
system, and consists of the following steps:
Autolearn devices on primary thermostat
Duplicate primary thermostat to secondary thermostats
Associate thermostats with relays
Reception timed out
Reached maximum number of programmable devices
Thermostat duplication procedure failed
Reset factory settings timed out
Firmware version request failed
Display Description
Note. If the problem persists or recurs frequently, it is recom-
mended to reposition the thermostat in an area with better radio
reception (see paragraph 4.5).
5.4 Error messages
In the event of a malfunction, the thermostat signals the condition
with an
message on the display, followed by a code indicating
the cause of the problem.
To Next Page
Loading...
Need help?
General
