relay1_dtmf_timed_relay_duration
Description Duration to keep the relay active
Values: Integer.
relay1_event_out_ringing
Description Which state the relay should be set to during outgoing
ringing.
Values: Integer, 0 = no change, 1 = activated, 2 = deactivated, 3 = slow
ash, 4 = fast ash
relay1_event_inc_ringing
Description Which state the relay should be set to during incoming
ringing.
Values: Integer, 0 = no change, 1 = activated, 2 = deactivated, 3 = slow
ash, 4 = fast ash
relay1_event_out_call
Description Which state the relay should be set to during outgoing call.
Values: Integer, 0 = no change, 1 = activated, 2 = deactivated, 3 = slow
ash, 4 = fast ash
relay1_event_inc_call
Description Which state the relay should be set to during incoming call.
Values: Integer, 0 = no change, 1 = activated, 2 = deactivated, 3 = slow
ash, 4 = fast ash
relay1_event_idle
Description Which state the relay should be set to during idle.
Values: Integer, 0 = no change, 1 = activated, 2 = deactivated, 3 = slow
ash, 4 = fast ash
relay1_event_error
Description Which state the relay should be set to during error (no IP / not
registered).
Values: Integer, 0 = no change, 1 = activated, 2 = deactivated, 3 = slow
ash, 4 = fast ash
A.6 SNMP Parameters
trap_receiver
Required: No.
Description: The IP address of the server receiving SNMP traps.
Values: IP address given in regular dot notation, e.g. 10.5.2.100
network
Required: No.
Description: Used, together with the network mask, to determine the
allowed network for reading the MIB on the IP station.
To Next Page
Loading...
Need help?
General
