Vinten Protouch Pro-6HDV System - Component Adjustments

27
Contents
Previous
Page
First
Page
Next
Page
Previous
View
Adjustments
Pan brake knob adjustment
9 Because its movement is restricted, the pan brake knob (15) may require adjustment after prolonged
use.
10 To adjust the pan brake knob:
10.1 Remove the securing screw (15.1) and pull the knob (15) off the shaft (15.2).
10.2 Turn the shaft (15.2) clockwise until the pan brake is fully applied.
10.3 Install the knob (15) on the shaft (15.2) approximately at right angles to the body of the head.
10.4 Turn the knob fully counterclockwise and ensure the brake is released. Turn the knob clockwise
and ensure the brake is applied before the knob reaches the end of its travel.
10.5 Readjust as necessary and secure the knob with the screw (15.1).
Fig 4.2 Pan and tilt brake knob adjustment
(15)
(3) (4.1)(3.1) (3.2) (4) (3.3)
(15.1)
(15.2)
(4.2)