44
Contents
Previous
Page
First
Page
Next
Page
Previous
View
45 Assemble and refit the leg assembly as follows (Fig 6.9):
45.1 Refit the two pivot blocks (12) on the swivel feature on the end of the leg sub assembly (10), and
secure using two screws (17) and two nuts (11).
45.2 Refit the pivot shaft (18) into the pivot blocks (12).
45.3 Refit a release lever (16) into both the left-hand (13) and right-hand (20) tripod interface
mouldings.
45.4 Install the spring (19) into the recess in one of the release levers (16).
45.5 Fit both left-hand (13) and right-hand (20) tripod interface mouldings together over the pivot
blocks (12), captivating the pivot shaft (18) and ensuring the spring (19) locates in both release lever
(16) recesses.
45.6 Secure left-hand (13) and right-hand (20) tripod interface mouldings together with screw (14).
45.7 Install the leg sub assembly (10) into the pivot housing (8) and secure with a pivot pin (9),
pressing the plain diameter in first.
Selector housing
46 Assemble the selector housing as follows (Fig 6.9):
46.1 Refit the selector cap (7) ensuring the internal detent cut-out aligns with the slot in the pivot
housing (8).
46.2 Refit the steel ball (6) and detent spring (5) into the slot in the pivot housing (8).
46.3 Install the retaining disc (4), aligning the centre cut out with the upstand on the pivot housing (8).
46.4 Secure the retaining disc (4) to the pivot housing (8) using three screws (3).
46.5 Apply the label (2) to the retaining disc (4), aligning the centre cut out with the upstand on the
pivot housing (8).
46.6 Install the key ring (1) into the centre of the pivot housing (8).
NOTE: Replace the right-hand tripod interface moulding (20). It may have been damaged by the
self tapping screw (14) when originally assembled.
NOTE: Replace the pivot housing (8). It may have been damaged by the knurled pivot pin (9) when
originally assembled.
NOTE: Replace the pivot housing (8). It may have been damaged by the self tapping screws (3).
To Next Page
Loading...
