Vinten Vector 70 - Page 71

71
Contents
Previous
Page
First
Page
Next
Page
Previous
View
26 3354-410 Seal plate 1
27 M005-912 Screw, countersunk head, socket, M4 x 10 mm long 3
28 Q500-040* ’Omniseal’, 1.380 in. shaft dia. x 3/32 in. nominal section 1
29 3354-406 Tilt Drag shaft 1
30 P600-014* Bearing, needle roller, radial, 19 mm ID x 27 mm OD x 20 mm long 1
31 3354-295 Pivot Pin 6
32 M006-714 Screw, cap head, socket, M5 x 25 mm long 2
33 M006-734 Screw, low-profile, cap head, socket, M5 x 10 mm long 2
34 3354-212 Actuator 40 mm (Left Hand) 1
35 3354-288* Lining (Tilt brake reactor) (Fig 6.10) 1
36 3354-265 Actuator shaft 1
37 3354-218 Pinion shaft 1
38 P605-007 Snap ring, external, 20 mm shaft dia. x 1.2 mm thick 2
39 P003-001* Bearing, plain flanged, plastic, 8 mm ID x 10 mm OD x 5.5 mm long 1
40 M004-812 Screw, grub, cone point, socket head, M3 x 5 mm long 2
41 3354-214 Bevel gear (pinion) 1
42 3354-216 Actuator 40 mm (Right hand) 1
43 3354-209 0.125 mm (0.005 in.) Shim. A/R
3354-217 0.075 mm (0.003 in.) Shim
3354-433 0.05 mm (0.002 in.) Shim
44 P001-018* Bearing, plain, du bush, 8 mm ID x 10 mm OD x 12 mm long
(Fig 6.3)(Fig 6.5)
-
45 L801-105 Pin, dowel, 1/8 in. dia. x 9/16 in. long (Fig 6.10) 1
46 3354-293 Serrated boss (Fig 6.10) 1
Fig 6.6 Vector 70/70H Pan and Tilt Head - Mechanism Housing Assembly (Cont)
Item Part No Nomenclature Qty