Vinten Vector 70 - Page 70

70
Contents
Previous
Page
First
Page
Next
Page
Previous
View
Fig 6.6 Vector 70/70H Pan and Tilt Head - Mechanism Housing Assembly
Item Part No Nomenclature Qty
1 M006-702 Screw, cap head, socket, M5 x 10 mm long 6
2 3354-16 Platform assembly (Vector 70) (Fig 6.11) OR 1
3354-46 Platform assembly (Vector 70H) (Fig 6.11)
3354-13 Mechanism housing assembly (Vector 70) OR 1
3354-43 Mechanism housing assembly (Vector 70H)
3 M006-703 Screw, cap head, socket, M5 x 12 mm long 4
4 M800-151 Pin, coiled-spring, 4 mm dia. x 12 mm long, mcp 2
5 3354-280 Block 2
6 N001-043* Bearing, plain, du bush, 1/4 in. ID x 5/16 in. OD x 3/8 in. long 6
7 3354-923SP* Vertical track assembly (Vector 70) OR 1
3354-924SP* Vertical track member assembly (Vector 70H) 1
8 M004-807 Screw, grub, knurled cup point, socket head, M3 x 5 mm long 8
9 3354-296 Pivot pin 2
10 3354-201 Balance mechanism housing 1
11 P302-016* Bearing, ball, radial, 20 mm ID x 32 mm OD x 7 mm long, two seals 3
12 3354-229 Shim (adjustment housing) 2
13 3354-54* Balance adjuster assembly (Vector 70) (Fig 6.7) OR 1
3354-55* Balance adjuster assembly (Vector 70H) (Fig 6.8)
14 3354-926SP* Drive arm assembly 1
15 3354-294 Pivot pin 4
16 3354-925SP* Horizontal track assembly 1
17 3354-206* Slim (Horizontal track member) (0.005 in.) A/R
3354-299* Shim (Horizontal track member) (0.003 in.)
18 3354-264 Rear tilt buffer (left hand) (Vector 70) OR 1
3354-51 Rear tilt buffer assembly (Vector 70H) 1
19 3354-936SP* Lower drive arm assembly 1
20 3354-297 Pivot pin 2
21 Q900H039* ‘O’ ring, 1/4 in. ID x 3/8 in. OD, Dowty 200-010-4460 1
22 3354-415 Seal insert 1
23 P605-003 Snap ring, external, 30 mm shaft dia. x 1.5 mm thick 1
24 P302-017* Bearing, ball, radial, 30 mm ID x 42 mm OD x 7 mm long, two seals 1
25 3354-414* Inner gasket 1