Vinten Vector 70 - Page 77

77
Contents
Previous
Page
First
Page
Next
Page
Previous
View
Fig 6.9 Vector 70/70H Pan and Tilt Head - Tilt Drag Mechanism
Item Part No Nomenclature Qty
1 3354-201 Balance mechanism housing (Fig 6.6) 1
2 M005-734 Screw, low-profile, cap head, socket, M4 x 10 mm long 5
3 3354-412*Gasket 1
4 M801-021 Pin, dowel, 6 mm dia. x 20 mm long 2
5 3354-18* Tilt drag shoe assembly (type B) 1
6 3354-403 Actuator link “B” 1
7 M801-001 Pin, dowel, 3 mm dia. x 10 mm long 2
8 J530-031 Spring, tension, 1.375 in. length, 0.313 in. OD, 5.20 lbf/in. rate 1
9 M806-014 Pin, coiled-spring, 3 mm dia. x 10 mm long, mdp 2
10 M801-009 Pin, dowel, 5 mm dia. x 25 mm long 2
11 M801-047 Pin, dowel, 3 mm dia. x 25 mm long 1
12 M005-736 Screw, low-profile, cap head, socket, M4 x 6 mm long 3
13 Thrust bearing, comprising: 1
N552-019* Bearing, needle roller, thrust, 0.502 in. ID x 0.927 in. OD x 0.078 in.
long, with cage assembly
1
N552-020* Washer, thrust, bearing, 0.502 in. ID x 0.927 in. OD x 0.030 / 0.032
in. thick
2
14 R900H011 ’O’ ring, 20 mm ID 1
15 3354-340* Drag knob 1
16 M600-006* Washer, plain, heavy, M5 1
17 3354-292* Knob bung 1
18 M006-737* Screw, low-profile, cap head, socket, M5 x 6 mm long 1
19 3354-416 Knob Boss/ Threaded shaft 1
20 M003-103 Screw, countersunk head, pozidrive, M2.5 x 8 mm long 3
21 3322-286 Drag knob retainer/stop (pan) detent version 1
22 3354-413 Outer boss 1
23 Q900H038 ’O’ ring, 3/4 in. ID 1
24 3354-400 Tilt drag cover 1
25 M004-803 Screw, grub, dog point, socket head, M3 x 8 mm long 1
26 3354-402 Actuator Link “A” 1
27 M801-032 Pin, dowel, 6 mm dia. x 14 mm long 1
28 3354-17* Tilt drag shoe assembly (type A) 1