Vinten Vector 70 - Page 80

80
Contents
Previous
Page
First
Page
Next
Page
Previous
View
Fig 6.10 Vector 70/70H Pan and Tilt Head - Tilt Brake/Balance Knob/Centre Lock
Item Part No Nomenclature Qty
1 3354-13 Mechanism housing assembly (Vector 70H) OR
3354-43 Mechanism housing assembly (Vector 70H) (Fig 6.6) 1
2 3354-279 Flap pin 2
3 3354-210 Flap spring (left hand) 1
NI 3354-215 Flap spring (Right hand) 1
4 M806-028 Pin, coiled-spring, 2 mm dia. x 10 mm long, mdp 2
5 J532-166 Spring, compression, 1/2 in. free length, 5/32 in. hole dia., 9.2 lbf/in. rate 2
6 3354-211 Flap guard (Moulding) 1
7 3354-285 Pin (Tilt brake bell crank pivot) 1
8 3354-246 Bell crank (Tilt brake) 1
9 L701-082 Fastener, push-on, standard, 0.156 in. shaft dia. x 0.010 in. thick 1
10 M005-734 Screw, low-profile, cap head, socket, M4 x 10 mm long 3
11 3354-284 Pin (Tilt brake shoe pivot crank) 1
12 M806-004 Pin, coiled-spring, 4 mm dia. x 10 mm long, hdp 2
13 M005-706 Screw, cap head, socket, M4 x 16 mm long 4
3354-30 Push rod/spring fork assembly tilt brake, comprising: 1
14 3354-267 Push rod / Spring fork. 1
15 M004-718 Screw, cap head, socket, M3 x 10 mm long 1
16 3354-269 Washer 1
17 M601-261 Spring, disc, 6.2 mm ID x 12.5 mm OD x 0.7 mm thick 19
18 3354-268 Pin 1
19 M005-811 Screw, grub, cone point, socket head, M4 x 10 mm long 1
20 Q001-015* ’O’-Ring, 5/16 in. nominal ID x 0.103 in. section, hardness 75 IRHD 1
21 M600-106 Washer, plain, light, M8 1
22 J532-164 Spring, compression, 5/8 in. free length, 1/2 in. hole dia., 15.6 lbf/in. rate 1
23 3354-218 Pinion shaft (Fig 6.6) 1
24 L801-105 Pin, dowel, 1/8 in. dia. x 9/16 in. long 1
25 3354-293 Serrated boss 1
26 3354-341* Counter balance knob 1
27 M600-006* Washer, plain, heavy, M5 1
28 M006-737* Screw, low-profile, cap head, socket, M5 x 6 mm long 1
29 3354-292* Knob bung 1