Press the Menu button during video mode to access the
settings. (recording need to be stopped)
System Settings
Recording will begin automatically after powering on
with a microSD card in the device. Each recorded file is
up to three minutes long, with old footage being
replaced when microSD card storage is full.
22 23
① Auto Event Detection
The camera will automatically record a video sequence
while a moving object is detected during parking. It will
stop recording without new movements.
② Time Lapse recording
Time lapse record a video at low frames at 1 / 2 / 3 / 5 /
10 fps, it keeps recording continuously without audio
recorded.
③ Low Bitrate Recording
This mode uses low bitrate to record video and audio,
and uses small file sizes for continuous recording.
Note: We recommend to buy VIOFO HK4 ACC hardwire
kit cable for parking mode recording.
Parking Mode:
There are 3 options under parking mode:
Resolution: Set the video resolution of footage recorded
2592 x 1944P 30fps, 2560 x 1600P 30fps, 2560 x 1440P 30fps,
2560 x 1440P 60fps, 2560 x 1080P 60fps, 2560 x 1080P 30fps,
2304 x 1296P 30fps, 1920 x 1080P 60fps, 1920 x 1080P 30fps,
are available for selection.
Bitrate: Low / Medium / High.
You can set the bitrate for video. High bitrate may
improve the quality and smoothness of the video,
especially when recording fast motion or high contrast
scenes. Using high bitrate mode may decrease the
amount of recording time available on your memory
card. Using a low bitrate will save space and record for
longer time.
Loop Recording: off / 1 / 2 / 3 / 5 / 10 minutes.
HDR (High Dynamic Range): Off/On/HDR Timer. The
default setting is Off. The multi-exposure HDR technique
helps automatically balance the lighting in over bright
and over dark areas to avoid over exposure issues.
Exposure: Adjust the value of the EV (Exposure Value) to
obtain better recording results under different light sources.
The range is from -2.0 to + 2.0. The default is set at 0.0.
Enter Parking Mode Timer: Set the timer for entering
parking mode. (Only for hardwire cable, if you
use external battery, this function will not work.)
"Off" means the camera will enter parking mode right
away when the engine is off.
"90s" means the camera will enter parking mode 90
seconds after engine is off.
Parking Recording Timer:
"Off" means the camera will keep recording until the
hardwire kits cut the power supply.
"1 hour" means the camera will shut down after it gets
into parking mode for 1 hour.
Parking G-sensor: The G-sensor detects significant or
sudden movement (such as an impact or collision), it will
trigger an event recording. We suggest setting it to High
sensitivity in parking mode recording.
To Next Page
Loading...
