2
1
7. Connect to Power
Insert the car charger USB cable’s male port into the camera
mount's USB Type-C port. Plug the USB power adapter into your
vehicle’s 12V / 24V female power socket.
Tips:
1. Do not install / mount the camera in a location that interferes
with the driver’s visibility and safety.
2. Install / mount the camera close to the rearview mirror so that
both sides of the scene being recorded are equally covered by
the camera’s FOV (field of view).
3. To ensure a clear view on rainy days, the lens should be
positioned within the windshield wiper’s sweeping range.
4. Do not install / mount the camera on or near airbag panels.
5. Installation / mounting location should not be affected by sun
control film (window tint). There should not be any other
electronic equipment close to the camera for optimal
performance.
Note:
Do not install / mount the camera or cables near an airbag panel
or within the airbag’s working range. The manufacturer is not
liable for any injury or death caused by deployment of the airbag.
8
4. Peel the protection film off the
sticky pad on the mount, and
attach it to the sticker. Press the
camera hard for a few seconds,
making sure it is attached firmly.
3. Peel the green sign protective film
off the static sticker.
1. Wipe clean the surface of the
windscreen before installation.
2. Peel the red sign protective film
off the static sticker, then attach
the sticker to the windscreen.
Press it for a few seconds, making
sure no bubbles are left.
3. Install the Static Sticker (Optional)
9
To Next Page
Loading...
