Parking Mode
There are three options for parking mode.
1. Auto Event Detection
The camera will automatically record a video sequence while a
moving object is being detected during parking mode. It will stop
recording when no new movement is detected.
2. Time Lapse Recording
Time lapse record a video at low frames at 1 / 2 / 3 / 5 / 10 fps, it
keeps recording continuously without audio recorded.
Note: Audio cannot be recorded in time-lapse mode.
3. Low Bitrate Recording
This mode uses low bitrate to record video and audio, and uses small
file sizes for continuous recording.
Note: Parking mode provides surveillance of your parked vehicle
only when the engine is off and the USB Type-C Hardwire Kit is used
to provide continuous power.The Hardwire Kit also protects your
car battery from being drained. We recommend buying the
VIOFO HK4 ACC hardwire kit cable for parking mode recording.
12
Recording Mode Behavior
Loop Recording
( Including Motion Detection )
DCIM \ Movie
DCIM \ Movie\ RO
DCIM \ Movie \ Parking
Emergency Recording
( Locked Video )
Parking recording ( Auto Event Detection /
Time-lapse Recording / Low Bitrate Recording )
Playback Video on VIOFO APP
Long press the button [ ] to enable Wi-Fi. Connect Wi-Fi on your
phone first. Open VIOFO app and choose "Connect your camera" to
use your phone to control the dashcam. You can play and manage
files through the APP. You can check the app introduction refer to
[Review and Control on Smartphone].
Video File Storage Location
Snapshot DCIM \ Photo
Playback and Manage Videos
Playback Video on PC
1. Remove memory card from dashcam. Before removing the
memory card, make sure you have switched off the dashcam.
2. Insert the memory card into a SD card adapter or card reader
connected to your PC.
3. Open the DCIM folder, using VLC or another video player to playback
the video.
Note: For your PC with a microSD slot, you can directly insert the
memory card into it.
13
To Next Page
Loading...
