Camera setup is available in the VIOFO App. Connect the App as
above, stop recording, then enter the settings menu.
Video Setting
• Video Resolution：
2560 * 1440P 30fps
1920 * 1080P 30fps
• Time-lapse Recording: Off / 1 / 2 / 3 / 5 / 10 fps.
Record video from frames captured at specific time intervals to
conserve memory and reduce the time it takes to review video. The
default is off.
• Recording Audio:
Turn on and off the microphone. This can also be changed during
recording by short press the [ ] button.
• Exposure Value:
Adjusting the value of the EV (Exposure Value) properly can create
better footage under different light sources. It ranges from -2.0 to
+2.0. The default is set at 0.0.
18
• Loop Recording: Off / 1 / 2 / 3 / 5 / 10 minutes.
Recording will begin automatically after powering on with a
microSD card in the device. Each recorded file is one minute long as
a default and the old footage will be replaced when microSD card
storage is full.
System Settings
• HDR (High Dynamic Range):
Off/On/HDR Timer. The default setting is Off. The multi-exposure HDR
technique helps automatically balance the lighting in over bright
and over dark areas to avoid over exposure issues.
• G-Sensor:
The G-sensor measures shock forces and locks the video recorded
at the time. The settings from “low to high” determine the amount of
force needed to lock the file from being overwritten. We
recommend that you set it at low.
• Date Stamp:
On / Off. Imprint the time and date on the recorded video.
• Bitrate: Low / Normal/ High / Maximum.
You can set the bitrate for video. High bitrate may improve the
quality and smoothness of the video, especially when recording fast
motion or high contrast scenes. Using high bitrate mode may
decrease the amount of recording time available on your memory
card. Using a low bitrate will save space and record for longer time.
• Wi-Fi Channel: Off / 2.4GHz / 5GHz
We recommend choosing the high speed 5GHz Wi-Fi mode.
• Time Zone:
Set the current time zone for GPS time and date calibration.
Note: the time zone must be manually adjusted for daylight savings.
• Time Synchronization:
Time synchronization with mobile phone.
System Setting
19
To Next Page
Loading...
