• App Version:
Check the current firmware version of the APP.
• Firmware:
Check the current firmware version of the camera.
Other
Caution:
Any changes or modifications to this device not explicitly approved
by the manufacturer could void your authority to operate this
equipment.
This device complies with part 15 of the FCC Rules. Operation subjects
to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Shenzhen VIOFO Technology Co., Ltd, declares that this Radio
Frequency peripheral is in compliance with the essential requirements
and other relevant provisions of Directive 1999/5/EC.
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed
and operated with minimum distance 20cm between the radiator &
your body.
Follow the instructions on this website to upgrade the firmware:
(https://viofo.com/content/42-help-and-support/)
Note:
• Before using a microSD card to upgrade the firmware, formatting
the card in the camera is necessary to ensure stable read and write
operation.
• Do not unplug or power off the camera during a firmware upgrade,
it may cause the camera to subsequently fail to boot.
FCC Statement
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
Firmware Upgrade
Notice
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio / TV technician for help.
24 25
To Next Page
Loading...
