Viofo VS1 - Parking Mode Settings

20
• Date Format:
You can choose the date format of the camera.
• Parking Mode:
There are 3 options under parking mode:
① Auto Event Detection
The camera will automatically record a video sequence while a
moving object is detected during parking. It will stop recording
without new movements.
② Time Lapse Recording
Time lapse records a video at low frames at 1 / 2 / 3 / 5 / 10 fps,
it keeps recording continuously without audio recorded.
③ Low Bitrate Recording
This mode uses low bitrate to record video and audio, and uses
small file sizes for continuous recording.
Note:
1. We recommend that you buy VIOFO HK4 ACC hardwire kit
cable for parking mode recording.
2. In case you park the car outside in hot summer, we highly
recommend time lapse recording mode. If the temperature
inside the car goes above 60°C, we advise turning off the
dashcam to avoid recording errors or even irreversible damages.
• Boot delay:
The camera will boot seconds delay when powered on. The settings
are off / 5s / 10s.
• Parking Recording Timer:
"Off" means the camera will keep recording until the hardwire kits
cut the power supply.
"1 hour" means the camera will shut down after it gets into parking
mode for 1 hour.
• Enter Parking Mode Timer:
Set the timer for entering parking mode. (Only for hardwire cable, if
you use external battery, this function will not work.)
"OFF" means the camera will enter parking mode right away when
the engine is off.
"90s" means the camera will enter parking mode 90 seconds after
engine is off.
• Voice Notification:
Turn on / off the voice notification.
• Parking G-Sensor:
The G-sensor detects significant or sudden movement (such as an
impact or collision), it will trigger an event recording. We suggest
setting it to High sensitivity in parking mode recording.
• Parking Motion Detection:
Adjusts the sensitivity of the motion detection so minor motion
caused by wind or rain doesn't trigger a recording.
• Image Rotate:
Turn the image upside down. You can set the camera image
rotation.
• Notification Sounds:
Off / Button beep only / Startup sound only / All on.
You can enable/disable the button and startup sounds.
• Image Mirror
Change the image reversely.
21