On / Off. The dynamic range is the ratio of the brightest portion of
the image to the darkest portion of the image. WDR enables the
camera to deliver video with a near perfect exposure in varying
lighting situations.
• WDR (Wide Dynamic Range):
The G-sensor measures shock forces and locks the video recorded at
the time. The settings from “low to high” determine the amount of
force needed to lock the file from being overwritten. We recommend
that you set it at low.
• G-Sensor:
① Auto Event Detection
The camera will automatically record a video sequence while a
moving object is detected during parking. It will stop recording
without new movements.
② Time Lapse recording
Time lapse record a video at low frames at 1 / 2 / 3 / 5 / 10 fps, it
keeps recording continuously without audio recorded.
③ Low Bitrate Recording
This mode uses low bitrate to record video and audio, and uses
small file sizes for continuous recording.
Note: We recommend to buy VIOFO HK4 ACC hardwire kit cable for
parking mode recording.
• Parking Mode: There are 3 options under parking mode:
On / Off. Imprint the time and date on the recorded video.
• Date Stamp:
You can set the bitrate for video. High bitrate may improve the
quality and smoothness of the video, especially when recording
fast motion or high contrast scenes. Using high bitrate mode may
decrease the amount of recording time available on your memory
card. Using a low bitrate will save space and record for longer
time.
• Bitrate: Low / Normal/ High / Maximum.
System Setting
• Time Zone: Set the current time zone for GPS time and date calibration.
• Time Synchronization: Time synchronization with mobile phone.
• Date Format: You can choose the date format of the camera.
• Boot delay: The camera will boot seconds delay when powered on.
The settings are off / 5s / 10s.
Note: the time zone must be manually adjusted for daylight savings.
21 22
To Next Page
Loading...
