Viofo WM1 - System Settings; Video Setting

Other
• Reset Camera Settings: Reset all settings to default values.
• Wi-Fi Name (SSID): Change Wi-Fi name.
• Wi-Fi Password: Change Wi-Fi Password. Wi-Fi default password is 12345678.
• Custom Text Stamp: Imprint the custom text on the recorded video.
• Car License Number: Imprint the car number on the recorded video.
• Free Space on Card: Show theremaining storage space on the microSD
card.
• App Version: Check the current firmware version of the APP.
• Firmware: Check the current firmware version of the camera.
25 26
Follow the instructions on this website to upgrade the firmware:
(https://viofo.com/content/42-help-and-support/)
Note:
• Before using a microSD card to upgrade the firmware, formatting the
card in the camera is necessary to ensure stable read and write operation.
• Do not unplug or power off the camera during a firmware upgrade, it
may cause the camera to subsequently fail to boot.
FCC Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
Firmware Upgrade
Notice