VIPA SSM-BG41 - Page 279

Manual BG41/BG42/BG43 List of figures
Rev. 99/49 A-3
Fig. 4-8: Structure of output sequence telegrams from 3964 (R) with...........................................4-46
Fig. 4-9: Example of an output.......................................................................................................4-47
Fig. 4-10: Structure of a normal input telegram .............................................................................4-48
Fig. 4-11: Structure of a sequence input telegramm.......................................................................4-48
Fig. 4-12: Example of an input telegram........................................................................................4-49
Fig. 4-13: Data and status register of the BG41/2/3 .......................................................................4-84
Fig. 4-14: status register interface channel .....................................................................................4-85
Fig. 4-15: Data register interface channel.......................................................................................4-86
Fig. 4-16: Status register parameter channel...................................................................................4-87
Fig. 4-17: Acknowledgement byte 1...............................................................................................4-88
Fig. 4-18: Acknowledgement byte 2...............................................................................................4-88
Fig. 4-19: Command byte parameter channel.................................................................................4-89
Fig. 4-20: Command byte command 0 ...........................................................................................4-90
Fig. 4-21: Command byte command 1 ...........................................................................................4-91
Fig. 4-22: Code/baud rate ...............................................................................................................4-92
Fig. 4-23: Example 1, changing the baud rate ................................................................................4-92
Fig. 4-24: Example 2, changing the baud rate ................................................................................4-93
Fig. 4-25: Changing the data format with command 3...................................................................4-94
Fig. 4-26: Example of how to change the data format of a channel...............................................4-95
Fig. 4-27: Operating the clock, command 4, instruction 01 ...........................................................4-96
Fig. 4-28: Operating the clock, command 4, instruction 02 ...........................................................4-97
Fig. 4-29: Operating the clock, command 4, instruction 03 .........................................................4-100
Fig. 4-30: Operating the clock, command 4, instuction 04...........................................................4-100
Fig. 4-31: Operating of the clock, command 4, instruction 05.....................................................4-101
Fig. 4-32: Function selection (protocols and procedures) with command 5, example 1..............4-102
Fig. 4-33: Function selection (protocols and procedures) with command 5, example 2..............4-103
Fig. 4-34: Function selection (protocols and procedures) with command 5, example3...............4-103
Fig. 4-35: Example of STX/ETX parametriezed with command 8..............................................4-105
Fig. 5-1: Mounting place in PLC-115U............................................................................................5-2
Fig. 5-2: Mounting places in PLC-135U ..........................................................................................5-3
Fig. 5-3: Mounting place in PLC-150U............................................................................................5-4
Fig. 5-4: Mounting place in PLC-155U............................................................................................5-5
Fig. 5-5: Mounting place in EG-185U..............................................................................................5-6
Fig. 5-6: Mounting places in PLC-188U ..........................................................................................5-7
Fig. 5-7: Position of the jumpers and the DIL switches on the BG43............................................5-11
Fig. 5-8: Circuit diagram of the building block BG43, for example ..............................................5-13
Fig. 5-9: How the diagnostic adaptor works...................................................................................5-19
Fig. 5-10: Pin allocation of the diagnostic socket...........................................................................5-20