VIPA SSM-BG41 - Fig. 3-31: Setting of the Mode SSI with Command 3

Functional description and allocation of terminal pins Manual BG41/BG42/BG43
3-32 Rev. 99/49
Command 3 - Setting the mode
When setting the mode, two additional bytes are transferred as argument.
Fig. 3-31: Setting of the mode SSI with command 3
Bit 3 in byte 1 is used as the control bit for the block commands. If this bit is set at 1, the command
applies for all connected sonsors of the channel.
The mode bits are occupied as follows:
Bit 0 to 4 (W0...W4) The bit length of the encoder telegram is adjusted here.
Standard value: 24
0 not permissible
1...24 area, which can be given. 1 corresponds to the bit length 1,
2 corresponds to the bit length 2 etc.
Bit 5 to 7 reserved and must be set at 0.