Manual BG41/BG42/BG43 Startup
Rev. 99/49 5-25
5.6.2 3964R
With this example a SEND order from interface 1 to interface 2 of the SSM-BG42 or the SSM-
BG43 is realised.
The SEND order is initiated by setting the M1.0. After the order is completed the M1.0 is reset. As
described in this example, the FB ‘SEND’ must run until "order completed" is reported back.
In the following the building blocks necessary for the two orders are given:
Cold Restart OB
OB20
BIB #6075
00000 :SPA FB 37
NAME #SYNCHRON
ADRE =KH F080 Base address
SSNR =KF +1 Interface number
BAUD =KF +10 Baud rate (9600)
FORM =KM 00000001 11111100 Parity even,2 Stop bits,8bits per byte
PRIO =KF +0 Low transmission priority
BLOC =KF +64 Block size between SPS and the card
ZVZ =KF +20 Character delay time 200 ms
QVZ =KF +220 Acknowledgement delay time 2200 ms
PAFE =MB 199 Error byte
NEUS =M 0.0 New start flag
0000C :
0000D :SPA FB 37
NAME #SYNCHRON
ADRE =KH F080 Base address
SSNR =KF +2 Interface number
BAUD =KF +10 Baud rate (9600)
FORM =KM 00000001 11111100 Parity even,2 Stop bits,8 bits per byte
PRIO =KF +0 Low transmission priority
BLOC =KF +64 Block size between SPS and the card
ZVZ =KF +20 Character delay time 200 ms
QVZ =KF +220 Acknowledgement delay time 2200 ms
PAFE =MB 199 Error byte
NEUS =M 0.0 New start flag
00019 :
0001A :BE
To Next Page
Loading...
