Manual BG41/BG42/BG43 Interface modules
Rev. 99/49 3-65
Command 1 - Reading the analogue value
Fig. 3-45: Reading of the analogue value of the analogue input/output with command 1
The line 0 .. 7 is assigned to the inputs or outputs.
The following bytes are returned as follows:
Bit No.
76543210
LSB
D7 D6 D5 D4 D3 D2 D1 D0
Bit No.
76543210
MSB
D15 D14 D13 D12 D11 D10 D9 D8
If this command is used on the output module, one receives the output’s set value in binary format.
To Next Page
Loading...
