©
2005
Directed Electronics, Inc.
19
5.
PPrrooggrraamm tthhee FFeeaattuurree..
While HOLDING the Valet/Program button, you can
toggle the feature on and off using the remote transmitter. For the second feature,
pressing will select the chirps ON setting and the siren will chirp 1 time.
Pressing will change the programming to the chirps OFF setting and the
siren will chirp twice. (See
System Features Menus
section of this guide.)
NOTE: For features with more than 2 settings pressing will toggle through
all the two-chirp settings and emit the corresponding number of chirps.
6.
RReelleeaassee tthhee VVaalleett//PPrrooggrraamm BBuuttttoonn..
Once a feature is programmed:
➤➤
Other features can be programmed within the same menu.
➤➤
Another menu can be selected.
➤➤
The learn routine can be exited if programming is complete.
To access another feature in the same menu:
1. Press and release the Valet/Program button the number of times necessary to advance from the
feature you just programmed to the next one you want to program.
2. Then press the Valet/Program button once more and HOLD it.
For example, if you just programmed the third feature in the menu and you would like to program
the seventh feature in the menu, you would press and release the Valet/Program button four times
and then press it once more and HOLD it. The siren would chirp seven times to confirm access to
the seventh feature.
To select another menu:
1. Press and HOLD the Valet/Program button.
2. After three seconds, the unit will advance to the next menu and the siren will chirp, indicating
which menu has been accessed.
For instance, if you just programmed some features in Menu #1 (Basic Features) and you wish to
program a feature in Menu #2, you press and HOLD the Valet/Program button. After 3-seconds,
the siren chirps twice indicating access to Menu #2. To advance to Menu #3, continue to HOLD
the Valet/Program button an additional 3-seconds until the siren chirps three times indicating access
to Menu #3.
To Next Page
Loading...
Need help?
General
