©
2005
Directed Electronics, Inc.
33
Exit Shock Sensor Adjustment Mode
The adjustment mode will be exited if:
➤➤
No input from transmitter for 15-seconds.
➤➤
No input from sensitivity testing for 15-seconds.
➤➤
The ignition is turned On.
➤➤
The Valet button is pressed.
The siren will emit 1 long chirp and the LED will extinguish which shock adjustment mode is
exited.
Reset Shock Sensor to Default Setting
The shock sensor can be restored to a default setting of 10 to facilitate re-adjustment at any time
while in adjustment mode.
1. Simultaneously press the and buttons.
2. The system will emit 3 chirps to indicate the sensor has been reset to level 10.
3. The system returns to shock sensor adjustment mode for further adjustment, if required.
Diagnostics
The system’s microprocessor monitors and reports all active and violated zones when arming and
disarming. LED flashes indicate the active or violated zone; siren chirps indicate system status.
Arm/Disarm Diagnostics
The number of siren chirps will indicate the status of the system when arming and disarming. For
information on which zone is active or has been violated refer to the
Table of Zones
.
To Next Page
Loading...
Need help?
General
