Viper 3000 Installation Guide

18
©
2005
Directed Electronics, Inc.
System Features Learn Routine
The System Features Learn Routine dictates how the unit operates. Due to the number of steps,
they have been broken up into three menus. It is possible to access and change any of the feature
settings using the Valet/Program button. However, this process can be greatly simplified by using
the 998T Bitwriter
®
. Any of the settings can be changed and then assigned to a particular trans-
mitter, up to four, a feature called Owner Recognition. Each time that particular transmitter is used
to disarm the system, the assigned feature settings will be recalled. Owner Recognition is only
possible when programming the unit via the 998T Bitwriter
®
.
If the system was previously programmed using the 998T Bitwriter
®
, the learn routine may be
locked. If the siren generates one long chirp when attempting to program the unit, the learn routine
is locked and must be unlocked using the 998T Bitwriter
®
.
1.
OOppeenn aa ddoooorr..
(The H1/8 GREEN wire or the H1/6 VIOLET wire must be
connected.)
2.
IIggnniittiioonn..
Turn the ignition on, then back off: (The H1/4 YELLOW wire must
be connected.)
3.
SSeelleecctt aa MMeennuu..
Press and HOLD the Valet/Program button: (The
Valet/Program button must be plugged into the blue port.) After three seconds
the siren will chirp once indicating entry to the Basic Features Menu #1. If this
is the menu you wish to access, release the button and go on to Step 4. If the
button is not released, you will jump to the Advanced Features Menu #2 and
the siren will chirp twice. If the button is still not released, you will jump to
Advanced Features Menu #3 and the siren will chirp three times. Once you
have selected the desired menu, release the Valet/Program button and then
proceed to Step 4.
4.
SSeelleecctt aa FFeeaattuurree..
Press and release the Valet/Program button the number of
times corresponding to the feature you wish to change. For example, to access
the second feature, press and release the button two times. Then press the
button once more and HOLD it. The siren will chirp the number of times
equal to the step you have accessed.

Viper 3000 Specifications

General

Model	Viper 3000
Category	Car Alarm
Remote Control	Yes
Number of Remotes Included	2
Door Lock Control	Yes
Trunk Release	Yes
Panic Mode	Yes
Valet Mode	Yes
Remote Start Ready	Yes
Range	1/4 Mile