button of the remote control for 1 second to disarm the
alarm.
“system” The siren will chirp twice, the lights will flash twice, the
doors will unlock if connected, and the led will stop flashing.
“remote” The remote control Notification will be two beeps, play
the disarm animation and then display the status icons.
Note: In Valet mode, when unlocking the doors, the remote
control Notification will be the disarm animation
Note: If more than 2 chirps are heard, the system may have
been triggered while armed and/or NPC activated. Please
refer to Disarm Diagnostics section of this guide.
➜
high security disarm
High security disarm will silence the siren and reset the alarm to the
armed state if the remote control
button is pressed more than six
seconds after the alarm is triggered. To disarm the alarm, the button
must be pressed again.
If pressed within six seconds of a trigger, the alarm will disarm as a
convenience in case of accidental triggers by the user.
high Security Disarm response
“system” The siren will stop sounding, the lights will stop flashing
and the alarm will remain armed.
“remote” There is no remote control Notification for High
Security disarms.
To Next Page
Loading...
