* This function determines the resolution to be used to record incoming MIDI
messages.
*TheRD-70TIMEBASEisusuallysetto96,butavalueof240canbeselected
ifdesired.
* The following table indicates the compatibility of the two values in relation
totheresolutionofthesongstoberecorded::
*TosettheTIMEBASE,proceedasfollows:
1)WhileholdingENTER,pressREC(thecurrentvaluewillbedisplayed).
2)ChangethevalueusingREWandFF.
3)PressENTERtoconfirm.
* This MIDI message enables the units forming the system to "sense
connection"withoneanother.
* Although almost all modern instruments can handle these messages, some
older ones do not interpret the code correctly: in this case, it is advisable to
disableproductionofthismessageasfollows:
1)While holding ENTER, pressSONG>(currentstatus ofthefunctionwillbe
displayed-ON/OFF).
2)ChangethestatusbypressingREWorFF.
3)PressENTERtoconfirm.
6.4TIME BASE Selection
6.5ACTIVE SENSING Function
MIDI
Other UnitsRD-70
192 24, 48, 96, 192, 384
240 30, 60, 120, 240, 480
To Next Page
Loading...