19
Viscount Physis OrgansReference Manual
N.B.
When the organ is switched on, it selects automatically the memory bank n.1.
10. MIDI section.
These controls, provided for each manual and the pedal board, allow transmission of the note MIDIcodes
on the MIDI [OUT] port to be enabled and disabled. All the instrument’s other MIDI messages will
continue to be transmitted, even with the MIDI control off.
11. Control and programming section.
The buttons and the display in this sections allow the user to program and set up the instrument and the
sequencer. This section is described in chapter 4 and following.
12. ORCHESTRA section.
Contains the orchestral voices. It is possible to select the voice activated by each rocker-switch, and adjust
the main sound generation parameters of each voice. For further information read par. 8.4.
13. Additional displays
- [CRESCENDO]: shows the step currently reached by the [CRESCENDO] pedal (point 26).
- [M. BANK]: displays the memory bank of the combinations (general and divisional), selected using
the [MEM. BANK +] and [MEM. BANK -] pistons, or by holding the [S] piston (p. 20) and using the
[PREV] and [NEXT] buttons (p. 14).
14. General combinations.
- [1] / [10] or [8] or [6]: pistons and (in some models only) toe pistons to recall the combinations saved
in the selected memory bank (several memory banks are available, and can be chosen by pressing
[MEM- BANK +] and [MEM. BANK -]). These combinations can be modified. To do so, follow the
procedure described at point 20.
- [HR]: restores the voice setup prepared in manual mode before a memory was recalled.
- [PREV.] / [NEXT]: general combinations sequencers. [PREV.] displays them in descending order,
[NEXT] in ascending order.
15. Pedal pistons.
- [1] / [6]: pedal divisional combinations. These combinations can be modified. To do so, follow the
procedure described at point 20.
- [HR] (only available for some models): restores the voice setup prepared in manual mode before a
memory was recalled, when the piston is on.
- [MIDI PD] (only available for some models): to allows transmission of notes played on the pedalboard
on the MIDI [OUT] output
16. Solo pistons
- [1] / [6]: Swell divisional combinations. These combinations can be modified. To do so, follow the
procedure described at point 20.
- [HR] (only available for some models): restores the voice setup prepared in manual mode before a
Solo memory was recalled, when the piston itself is on.
- [SO/P]: Solo to Pedal coupling.
- [M.SOLO] (only available for some models): activates the MIDI SOLO function, which allows mono
transmission of the notes played on this manual on the MIDI [OUT] output, with priority to the
highest note.
To Next Page
Loading...
Need help?
General
