31
Viscount Physis OrgansReference Manual
instructing you to press [ENTER] to confirm the new voice and render it usable. The voice on which the
cursor is located is available and can be played even before [ENTER] is pressed, allowing the modification
required to be evaluated immediately. Other stops can also be switched on to assess the overall effect of the
changes.
Press [EXIT] to replace other voices or exit the function. The changes made are automatically saved into the
current organ style.
NOTE
When an alternative voice is selected, the sound generation parameters in the EDIT PARAMETERS
function are automatically reset to the default values of the new voice. The volume setting (in the
VOLUME LEVEL function) remains unchanged.
8.4 SELECTING AND ADJUSTING THE ORCHESTRAL VOICES
The same operations described in the chapter above can be performed also with orchestral voices, with a
single exception: the list of alternative voices and audio parameters are the same, regardless of which register
is selected at the moment.
To see the list of alternative voices, access the ALTERNATIVE VOICES function, then press and hold for
a few seconds the ORCHESTRA stop (or the normal organ stop which has orchestral alternative voices as
well) of the desired section, or move the cursor on the orchestral voice that you wish to replace and then
press [ENTER]:
As you may notice, there are three types of orchestral stops:
- Single: a single stop played on the whole manual / pedalboard. This kind of voice is shown with the
name of the single stop.
Orchestral timbre
- Split: two stops (named Left and Right) played in two different halves of the manual / pedalboard.
The split point can be changed. This kind of voice is shown as the names of the two stops hyphenated.
Left orchestral timbre Right orchestral timbre
Split key
To Next Page
Loading...
Need help?
General
