23
Viscount Physis OrgansReference Manual
4. PROGRAMMING SECTION AND MAIN SCREEN
When the instrument is turned on, it needs a few second to actually start working. In this stage, the lights on
the manual pistons glow in sequence and the display shows the introduction screen.
When the display shows the main screen, the organ is ready to play.
Models equipped with
divisional combinations
Models not equipped with
divisional combinations
The top of the screen shows the following fields to access the configuration sub-menus:
o TUNING: instrument tuning parameters (chap. 6).
o VOICES: functions relating to all the organ’s voices (chap. 8).
o STYLE: style selection (chap. 7).
o SET-UP: organ general set-up functions (chap. 9).
o UTIL. & MIDI (Utility & MIDI): utility and MIDI functions (chap.10).
o FILE MANAG. (File Manager): management of the files saved in the internal memory or the USB
device (chap.11).
To display the contents of a menu, simply locate the cursor (in reverse mode) on the field required using the
[FIELD S] and [FIELD T] buttons and press [ENTER]. [EXIT] quits the menu and returns to the main
screen.
The bottom of this screen displays the instrument parameters, which are always useful to know:
o [box on top left]: (“Equal” in the screen shown above) displays the temperament currently in use,
selected in the TUNING menu.
o ENSEMBLE: the ENSEMBLE value set in the TUNING menu.
o AIR PRESS: the AIR PRESSURE parameter value set in the TUNING menu.
o A: the instrument’s tuning, expressed as the frequency of A4, set in the TUNING menu.
o [box in top right-hand corner]: (User2 or Baroque in the screen above) contains the style selected (see
STYLE menu).
o P. COMB (in the models equipped with divisional memories): the status of the PISTON COMBINE
function as set in the UTILITY & MIDI menu.
o T. TOUCH (in the models not equipped with divisional memories): the status of the TRACKER TOUCH
function as set in the UTILITY & MIDI menu.
o K. INV: the status of the KEYBOARD INVERSION function (see UTILITY & MIDI menu).
o TRANSP: the transposition set in TUNING.
These are only information fields and cannot be selected or modified. To set the function they describe, enter
the menus listed above.
The buttons to visualize and navigate through all the display screens are located near the display.
To Next Page
Loading...
Need help?
General
