44
Viscount Physis Organs Reference Manual
NOTES
- As long as the Pedal Automatic Piano function is assigned to the [A.P.] piston, its position will
not be saved in the combination, not even when the SWS AND A.P. INTO GENERAL PISTON
function is active.
- Some of the screens described above appear only in certain models and therefore may not appear
in your instrument.
The [A.P.] piston function:
Select PD/GT MONO to activate the Monophonic Pedal function (with piston on). This function allows to
play pedalboard registers on the Great. When doing this the pedalboard is deactivated and the stops become
monophonic, with priority on the lowest note.
Select PED AUTOM. PIANO to activate the Pedal Automatic Piano function (with piston on). This function
automatically adjusts the sound composition of the pedalboard, according to the manual currently played.
- INT. GEN. VOLUME: only the internal amplification volume
- INT. &EXT. VOLUME: the volume of both the internal amplification and of the signal of the rear
outputs [PROG. OUT] and [GEN. SUB].
- EXT. GEN. VOLUME: only the volume for the signal of the rear outputs [PROG. OUT] and [GEN. SUB]
- NOTHING: do nothing.
To save the state of the MIDI stops and of the [M.SOLO] pistons to combinations (this screen will appear
only in models that allow to transmit MIDI codes).
To switch off the light of MIDI stops and [M.SOLO] pistons, when the Cancel piston is pressed (this screen
is available only in models that allow to transmit MIDI codes).
To Next Page
Loading...
Need help?
General
