Vision MAX Pro User Manual

Example Jobs 163
© 2015 Vision Engraving Systems
In the Vision software, open a new file and select Engrave, then Engraving Defaults from the top menu
bar. Select the Outside Ring S4 driver and make sure the Y Move field is set to 0.000. Select Apply and
Close to save this setting.
Select Engrave, then Ring Engrave from the top menu bar. The Ring Dimensions window will appear.
Set the driver to Outside Ring S4, then enter the ring size and width measured in the prior step. In this
example, the ring was a size 9.0 and the width was 0.314 inches. Select Next to proceed.

Vision MAX Pro Specifications

General

Brand	Vision
Model	MAX Pro
Category	Engraver
Language	English