Visonic KP-250 PG2 - Page 11

3. Arming and Disarming the System
D-304269 KP-250 PG2 User’s Guide 11
Initiating Fire Alarm or Emergency Alarm
You can generate a fire alarm or a silent emergency alarm in disarmed & armed states, as follows:
PRESS RESULTING DISPLAY
FIRE ALARM
OR
EMERGENCY
for 2 seconds
Then, if or when the system is in
the disarmed state:
HH:MM READY
(alternating)
READY MEMORY
To stop the alarm, press and then key in your valid user code.
Chime ON/OFF
Disable / enable the chime zones by alternate clicking of the key, as shown below:
PRESS RESULTING DISPLAY
CHIME ON
CHIME OFF

HH:MM READY
CHIME indicator lights steadily on the KP-250 PG2 keypad, when “chime on” is selected.